
Yearly Service for Gas Fireplaces and Log Sets
A gas fireplace has a flame, a vent and a safety shutoff, and each needs a look once a year. We quote the annual service at the free visit, ahead of any work.
PGW's safety guidance to its Philadelphia customers is direct: have gas appliances inspected by a professional at least once a year, and have the chimney and flue serviced regularly. A gas fireplace or log set is one of those appliances, even if it only runs on winter weekends. Because it burns clean and looks the same from year to year, it is the one most likely to be skipped.
What builds up is mostly out of sight. Dust and lint settle in the pilot and burner ports, spiders nest in the pilot tube over the summer, logs shift, and the vent collects debris or works a joint loose. None of that stops the fireplace from lighting at first. It shows up later as a lazy yellow flame, a filmed or sooty glass front, a pilot that drops out, or a vent that no longer clears exhaust the way it should.
When to call
- Glass with a white or gray film
- A flame lower, yellower or noisier than it used to be
- A pilot that takes several tries to light
- Logs or embers that have shifted or crumbled
- No service in more than a year
The visit, step by step
- Check the vent firstWe look at the vent or chimney inside and out, including the cap or outside termination, for blockages, gaps and damage.
- Clear pilot and burnerThe pilot hood, flame sensor and burner ports are cleared of dust and webs.
- Glass, gasket, logsThe glass comes off for a wipe-down, the gasket is checked, and logs or media go back in the manufacturer's layout.
- Light and testWe run a full cycle, check the flame and the safety shutoff, and note anything that needs a part.
What the yearly service covers
The service is about the flame and the vent, not just shiny glass. A typical visit includes:
- The vent or chimney checked top to bottom, including the cap or outside termination
- Pilot assembly, flame sensor and burner ports cleared
- Glass wiped and its gasket checked for a tight seal
- Logs, embers or glass media set back in the manufacturer's layout
- Gas connections at the unit checked for leaks
- Flame and safety shutoff tested through a full cycle
- Any worn part noted with its price before anything is replaced
Gas logs in an old masonry chimney
A vented gas log set in a former wood fireplace sends its exhaust up the same masonry flue the wood fire used. That flue still needs care. The 2021 IRC asks that a chimney be examined before a gas appliance is connected, and cleaned if it once vented wood (G2427.5.5), and the chimney's cap, crown and liner still decide whether exhaust leaves the house. In Philadelphia the stack may also stand beside a neighbor's flues, and an addition next door can leave its top too low. A yearly service is when we catch those changes.
CO alarms and the gas fireplace
A gas fireplace burns fuel, so the rooms around it need working carbon monoxide alarms. PGW recommends changing alarm batteries twice a year and replacing the alarm every five years. In Philadelphia, the city Fire Code has the seller certify in writing to the buyer that required smoke and CO alarms are installed and working. Statewide, Pennsylvania's Act 121 of 2013 requires CO alarm information on the seller's disclosure for one- and two-family homes. We look at your alarms during the service and tell you if one is missing or past its date.
Booking and price
We quote the yearly service at the free visit, ahead of the work, since units, vents and log sets differ so much. Pick any day except Saturday; we phone the day before. Fall fills up fast, so a visit in late summer or early fall gets the fireplace ready before the first cold night.
Answers
Gas Fireplace Service questions
How regularly does a gas fireplace need servicing?
Once a year. PGW asks customers to have gas appliances inspected by a professional at least yearly, and a gas fireplace is no exception even if it runs only a few nights a season.
How long can I leave a gas fireplace on?
Your manual sets the limit, and it differs between heating-rated inserts and decorative log sets. Turn it off and call for service if the glass soots up, the room smells of exhaust, or a CO alarm sounds.
Does a gas fireplace flue need sweeping?
Gas leaves little soot, but the flue still collects nests, leaves and fallen mortar, and an old masonry flue may still hold wood creosote. We check it at every service and sweep it when it needs it.
What are the signs of carbon monoxide in the house?
UGI lists condensation on windows, headaches, dizziness and flu-like symptoms. CO has no smell, so a working alarm matters most. If one sounds and anyone feels ill, get out and call 911.
Does PGW say to have the chimney checked?
Yes. PGW's safety page tells customers to have appliances, the chimney and the flue serviced regularly by a qualified technician, and not to cover appliance vent openings with mesh or netting.
Schedule
Choose a morning or an afternoon.
Sunday through Friday, arrival between 8 and 11, 11 and 2, or 2 and 5. The look costs nothing, and a person phones you the day before.
